DICE Silverline DUO Guía de instalación descargar pdf (Pagina 12)

ATTENTION! There are two 3-pin connectors presented in the vehicle. During installation,

make sure that the 3-pin connector from the vehicle does not have a brown wire in the

middle. The 3-pin connector of the phone pre-wiring looks identical to the 3-pin connector of

the CD changer pre-wiring! Do not use the 3-pin connector that has a brown wire in the

middle, but locate the one that has the brown wire on the side! Incorrect connection will

result in permanent damage to the unit and will not be covered by warranty!

5 Locate both the 3-pin & 6-pin connectors in the trunk area. If the CD Changer is present, disconnect the cables

and set aside. If no CD Changer is present, the cables will be bundled and tucked away in the rear trunk area.

Some vehicles will have the CD Changer wiring in a protective sheath which may make it

more difficult to locate. Cars sold outside the USA may not be pre-wired for trunk install,

and require additional harness to be connected.

6 Connect both 3-pin and 6-pin cables to the DICE BMW interface cable.

DICE vehicle harness3-pin and 6-pin BMW cables

7 Fold down rear seats (if applicable) and route the extension cable to the rear seat bottom cushion.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Sin comentarios

DICE Silverline DUO Guía de instalación Pagina 12